5554-513
22" ELECTRIC SNOW BLOWER
18
WARNING!
If any parts are damaged or missing, do not operate this product a
until the parts are replaced. Using a product with damaged or missing parts could
result in serious personal injury.
WARNING!
Do not attempt to modify this product or create accessories not
recommended for use with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading to possible serious
personal injury.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
The handle is not in position.
The bolts are not
properly seated.
Make sure the bolts are correctly
installed through the handlebars.
Check to see if the hand knobs are
tight. Refer to Assembling the Handle,
page 9.
The snow blower does
not start.
The switch is defective.
The extension cord is not
connected to the plug.
The extension cord is not
connected to the power source.
Have the switch replaced by an
authorized service centre.
Connect the plug on the snow blower
to the extension cord.
Plug the extension cord into a live
120VAC, 60 Hz outlet.
The motor is on, but the
impeller does not turn.
The belt is damaged.
Replace the belt. Refer to Replacing
the Belt and Pulley, page 15.
The snow blower leaves a
thin layer of snow behind.
The scraper is worn.
Inspect the scraper for wear or
damage. Replace the scraper. Refer to
Replacing the Scraper Bar, page 15.
Summary of Contents for 5554-513
Page 20: ...19 EXPLODED VIEW...
