5) Remove 2(5mm x 8) phillips head
screws that secure the plastic
backrest cover to
the metal backrest frame (Figure 6b).
Using a 10mm hex key wrench,
attach backrest frame to seat back
support using 4(10mm x25) socket
head cap screws.(See Figure 5 a.)
6) Connect backrest quick connect plug
to chair connector plug (tie up the
excess wire harness with a cable tie).
(See Figure 5 a.)
Figure 5 a
4) Remove the side cover and attach each
armrest to side frame as shown in
Figure 4 (it may be necessary to lightly
lubricate armrest shaft with silicone lube).
Figure 4
1) Plug chair into 120VAC outlet.
2) Turn on the main power switch located on the left side of the pump cover. A green lamp
will illuminate.
3) Raise the seat by foot switch.
To avoid the risk of electrick shock, this equipment must only be connected to a supply mains with
protective earth. Grounding reliability can only archieved when the equipment is connected to an
equivalent receptacle marked HOSPITAL ONLY or HOSPITAL GRADE.
CAUTION
Operate the Main Power Switch by hand only. Turn off the main switch after daily operation.
CAUTION
Do not touch a switch on the foot control during the main power switch is being turned on.
NOTE
4-2. Installation
Armrest
Side Frame
Side Cover
Screw
(5mm x 10)
Armrest Spring
Flat Washer(O.D.22 x I.D.6.5)
Armrest Screw(6mm x 80)
Backrest Frame
Socket Head Cap Screw
Seat Back Support
Chair Connector Plug
Backrest Quick Connect Plug
(10mm x 25)
- 5 -