Backrest Cover
Backrest Cushion
Alignment Bolts
Eyelet Holes
Threaded Brackets
Phillips head screws
Backrest Frame
(5mm x 8)
Round Head Screws
(1/4 - 20 x 3/4)
7) Re-attach plastic backrest cover to
backrest frame, as follows;
a) Insert backrest cover alignment
bolts into eyelet holes in backrest
frame, as shown in figure 6a.
b) Connect wire harness from back
rest membrane switches to
connector PC Board on the Back
rest Frame.
c) Press backrest cover against
backrest frame and push
backrest cover upward.
Make sure the 2 small threaded
brackets on the lower edge of the
backrest frame are inside of the
backrest cover.
d) Secure backrest cover to
backrest frame by using 2
(5mm x 8) phillips head screws,
as shown in figure 6b.
Figure 6a
Alignment Bolts
Backrest Cover
Backrest
Frame
Eyelet Holes
Figure 6b
Headrest Cushion
Headrest Mechanism
Phillips Flat Head Screw
(10 - 24 x 3/4 )
Headrest Bar
8) Attach headrest cushion to headrest
mechanism by using 4(10-24 x 3/4)
phillips flat head screws and slide
headrest bar into opening in top of
backrest. (See Figure 6c)
Figure 6c
- 6 -