Belmont SP-CLEO II, Operating Instructions Manual, Page: 30 / 48

- 26 -
BEEP＝ON Ｆ＝↓
（－）＝OFF (＋）＝ON
min. sec.
sec.
(Example) Case of "with switch tone"
Tone off Tone on
Frequency High
Frequency Low
Return to initial setup
Press once
min. sec.
LP.MODE＝HOLD Ｆ＝↓
（－）＝FOOT (＋）＝HOLD
(Example) Case of holder mode
Revolution mode holder mode
4. DESCRIPTION OF OPERATION AND FUNCTIONS OF COMPONENTS
Selection and change of key touch tone
With or without beep tone that is issued when a switch is
pressed can be selected, and the beep tone frequency (tone
quality) can be changed.
(It is not possible to control the volume of the selected
frequency.)
[Procedure for setup]
1. Press the function switch four times.
2. Press the relevant setup switches from the following.
To turn off the tone --------------------------
To sound the tone ----------------------------
To increase the frequency ------------------
To decrease the frequency ------------------
To change the frequency to initial setup --
[Precautions for change to frequency]
Ensure to press the switch on finishing the frequency
change.
The contents of frequency setup are not displayed on the
indicator. However, the switch tone sounds each time when
the frequency is changed. Confirm the frequency change by
hearing the tone.
Selection of handpiece light on timing
The handpiece light on timing can be selected from the two
mode:
1) Rotation mode
The light is turned on while the handpiece is running, and is off
upon elapse of the set light remaining time after termination of
handpiece running.
2) Holder mode
The light is turned on when the handpiece is picked out of the
holder.
[Procedure for setup]
1. Press the function switch five times.
2. Press the desired setup switch.
Rotation mode ----- switch
Holder mode ------- switch
5
4