- 22 -
Ｎo.４ ＳＣＡＬＩＮＧ
Bar graph (1 ~ 8)
The selected mode is displayed
Mode switching
4. DESCRIPTION OF OPERATION AND FUNCTIONS OF COMPONENTS
This recurrence mode is the rotation mode that always appears first
when a micromotor is picked up after the main switch is turned on.
It is convenient if a rotation mode frequently used is set as the
recurrence mode.
[Procedure for setup]
1. Turn on the main switch, and pick up a micromotor from the holder.
2. Select a desired rotation mode (limit mode or preset mode) to be set.
3. Press the store switch for about 2 seconds and the buzzer
sounds to confirm that setup of the selected rotation mode has been
completed.
2-15-4. Description of recurrence mode at the time of power on and setup
2-16. Operation and display of electric scaler
When the VARIOS scaler or P-MAX scaler is picked up from the
holder, the selected mode is displayed on the indicator, either PERIO,
ENDO or SCALING.
For switching the mode, use the (-) switch or (+) switch on the
membrane switch panel.
The EMS scaler does not provide this mode selection.
Sliding the foot controller pedal right and left can change the output
of the P-MAX scaler.
When the pedal slides to the right-hand end, the output becomes the
maximum, and the output is displayed by a bar graph on the indicator
even before the operation begins.
The P-MAX scaler does not permit output change during operation.
Once stop the motion, adjust the output, and restart the operation.
Sliding the foot controller pedal right and left can change the output
of the VARIOS scaler or EMS scaler during operation.
When the pedal slides to the right-hand end, the output becomes the
maximum, and the output is displayed by a bar graph on the indicator
during the operation.
Carefully read the instruction manual and other documents attached to each scaler before use,
and correctly use the scaler
CAUTION
Ｅ Ａ
No.2 SET2
20000rpm