Preset position setup procedures
1. Move the chair to the treatment position using manual switches.
2. Upon deciding of the desired treatment position, keep pressing preset switch , or to be set
for about 5 seconds. The buzzer sounds from the chair, and setup has been completed.
3. To change the set position, perform the procedures steps 1 and 2 above.
1. Move the chair to the rinsing position using manual switches.
2. Upon deciding the desired rinsing position, keep pressing last position switch for about 5 seconds.
The buzzer sounds from the chair, and setup has been completed.
3. To change the set position, perform the procedures steps 1 and 2 above.
Last position setup procedures
- 17 -
4. DESCRIPTION OF OPERATION AND FUNCTIONS OF COMPONENTS
Chair manual switch
Switches for manual up/down/backrest reclining of the chair.
Press to raise the chair.
Press to lower the chair.
Press to recline the backrest.
Press to get up the backrest.
Chair preset switch
Chair auto return switch
Set the chair height and backrest angle in desired position(s), and
actuate the chair by either one of these switches.
Press any switches(chair/unit) for stopping the automatic movement.
When this switch is pressed, the chair moves downward to the initial
position, and the backrest rises to upright position.
Press any switches(chair/unit) for stopping automatic movement.
When this switch is pressed in the fine-adjusted treatment position, the
chair moves to the rinsing position. When the switch is pressed again,
the chair returns to the former treatment position.
Chair last position switch
When operating the chair by the auto return switch, be careful not to nip the stool or the like by the
chair backrest. Damage to the backrest, stool and/or doctor table could be caused. Furthermore, at
the time of motion of the chair, ensure that the patient is sitting in a normal position and keep your
eye on the patient while the chair is in motion.
CAUTION
Ｅ Ａ
Ｅ Ａ
3
1
2
4
Ｅ Ａ
Ｅ Ａ
Ｅ Ａ
Ｅ Ａ
Ｅ Ａ
Ｅ Ａ
Ｅ Ａ
Ｅ Ａ