-6-
8-3. Adjusting the tension of the light head
1. With a No.2 Phillips head screwdriver, unscrew the M3x5 screws, and remove the left and right yoke caps.
2. Adjust the tension by equally tightening or loosening the two socket head screws using the supplied 1.5mm
Allen key.
3. Upon completion of the adjustment, reattach the left and right yoke caps that were removed in Step 1 with
a No.2 Phillips head screwdriver and the M3x5 screws.
Ensure that adjustments are made equally to both left and right sides.
Failure to do so may result in excess slack or damage.
8-4. Balance arm adjustment (lateral movement)
If the movement of the balance arm is either too loose or too tight, follow the procedures below to adjust.
1. Loosen the four M5 socket head screws (E) with the supplied 2.5mm Allen key.
When adjusting, make sure that the socket head screws are loosened.
Failure to do so may cause damage to the threads of the M8x20 screws.
Yoke Cap
Screw (M3x5)
Socket Screw
Yoke Cap
Balance Arm
Balance Arm Joint
Light Pole Joint
Light Pole
(E) M5 Socket Screw x 4pcs.
(D) M8x20 Screw (Bottom)
(D) M8x20 Screw (Top)
CAUTION
CAUTION
2. Adjust the lateral tension of the balance arm by tightening or loosening the top and bottom M8X20
screws of the balance arm joint (D). (Use a No.3 (big) Phillips head screwdriver.)
3. Upon completion of the adjustment, retighten the four M5 socket head screws (E) that were loosened in
Step 1 with the supplied 2.5mm Allen key.
Upon completion of the adjustment, make sure to retighten the socket head screws.
Failure to do so may render the balance arm immobile or may damage the M8x20 screws.
CAUTION