Belling IDW604MK2, Instruction Manual

Page: 23 / 30

Tension adjustment of the door spring ●
Connection of drain hoses
●
Tension adjustment
of the door spring
【 】
Figure5
The door springs are set at the factory to the proper tension for the outer door.
If aesthetic wooden panel are installed, you will have to adjust the door spring
tension. Rotate the adjusting screw to drive the adjustor to strain or relax the
steel cable(see figure 5).
relax
Adjust the door spring
tension until the door
remains balance in the
fully-opened position.
Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it
run into the sink, making sure to avoid bending or crimping it. Use the speical
plastic support that comes with the appliance (figure 6).
to avoid the back flow of it. : The special plastic hose support must be
solidly fastened to the wall to prevent the drain hose from moving and allowing water
to spill outside the drain.
The top of the hose must be at
a height between 40 and 100cm. The free end of the hose must not be immersed in
water
Drain pipe connection
【 】
Figure6
φ
40mm
A
B
C
Counter
Front
Drain pipe
Drain hose hook Close the drain hose hook to the counter
NOTE
The top of the hose
must be at a height
between
40 and 100cm.
The free end of the
hose must not be
immersed in water.