Belling 444410715, User Manual, Page: 5 / 13

5
INSTALLATION INSTRUCTIONS
• Assembly and electrical connections must be carried out by specialised personnel.
• Wear protective gloves before proceeding with the installation.
• Electric Connection:
- The appliance has been manufactured as a class II, therefore no earth cable is necessary. The
power point must be easily accessible after the installation of the appliance. If the appliance is
equipped with power cord without plug, a suitably dimensioned omnipolar switch with 3 mm mini-
mum opening between contacts must be fitted between the appliance and the electricity supply in
compliance with the load and current regulations.
- The connection to the mains is carried out as follows:
BROWN = L line
BLUE = N neutral.
• If the hob is electric, gas, or induction, the minimum distance between the same and the lower
part of the hood must be at least 65 cm. If a connection tube composed of two parts is used, the
upper part must be placed outside the lower part (Fig.3).
Do not connect the cooker hood exhaust to the same conductor used to circulate hot air or for
evacuating fumes from other appliances generated by other than an electrical source.
Before proceeding with the assembly operations, remove the anti-grease filter(s) (Fig.1) so that
the unit is easier to handle.
- In the case of assembly of the appliance in the suction version prepare the hole for evacuation
of the air.
• We recommend the use of an air exhaust
tube which has the same diameter as the air
exhaust outlet hole. If a pipe with a smaller
diameter is used, the efficiency of the product
may be reduced and its operation may become
noisier.
FIG.1
• If your appliance has been designed for
use in habitations supplied with a centralised
suction device perform the following opera-
tions:
- The switch controls opening and closure of
a valve using a thermo electrical device. By
placing the switch in the ON position, after a
minute, the valve opens rotating 90° allowing
suction of the stale air. By placing the switch
in the OFF position, the valve closes after 100
seconds.