Copiscan 8000 Plus Series Operator Manual
www.bellhowell.imagingcomponents.com
August 25, 2000
1-800-SCAN495
61
Figure 37. Removing the Glass Flat
3. Push down on the left end of the glass and slide the glass to the right until you see the
edge of the glass flat on the left side. The glass flat will slightly lift away from the
metal tray for you to grasp it.
4. Holding the left side, gently pull the glass flat towards the left. Take care not to twist
or leverage the tip where it still touches the scanner.
5. Check the glass flat for chips and scratches.
NOTE:
If the glass flat is chipped or scratched, use the Reorder Fax Sheet on the 8000 Plus
CD or call your Bell & Howell sales representative to order a new glass flat. Refer to
the Contact Information page at the front of this manual. You may also visit our online
store at
www.bellhowell.imagingcomponents.com
.
6. Using the optic cleaning pad, (Maintenance Kit Item #5) carefully clean the front and
back surfaces of the glass you want to install. Inspect the glass flat after cleaning to
ensure all dust and residue have been removed.
