0
1
0
1
Not Matching/Not Synced
Remote
Surge Protector
0
1
0
1
Remote
Surge Protector
Matching/Synced
iNStallatiON, mOUNtiNG aNd
SYNCiNG iNStRUCtiONS
wireless Remote Switch with wall-mount
Use either adhesive tape or screws (not
included) to attach the wall bracket securely to
a wall. Place the wireless remote switch near
existing light switches or near the entrance
to a room for added convenience and
accessibility. The wireless remote switch can
also be kept in any other convenient location,
e.g., by a bed, on a coffee table, or on a desk.
Conserve Switch Surge Protector (Optional)
Use the two mounting holes on the back of
the Surge Protector to secure it to the wall or
baseboard. Install two screws (not included),
leaving at least ¼ inch of the screw exposed.
Insert the screws into the mounting holes of
the Surge Protector and lock into place. Use
the detachable cable-management system
(included) to help route and organize cables.
Syncing your Conserve Switch Surge
Protector and wireless Remote Switch
By default your Conserve Switch Surge
Protector and remote should be synced when
purchased. However, if you need to change
the sync settings for any reason, you can do
this by locating and changing the channel
setting switches on the back of the remote
and on the back of the Surge Protector. On
the back of the remote, under the battery
cover, there is a series of three switches
that can be set to up to eight different
configurations. On the bottom left corner of
the back of the Surge Protector, there is a
similar set of switches. The switch settings
on both the remote and Surge Protector must
match in order for the remote to communicate
with the Surge Protector. You can use a small
screwdriver to shift the switches.
By adjusting these channel setting switches,
you can control multiple Conserve Switch
Surge Protectors with a single remote switch.
Adjust the channel setting on each Conserve
Surge Protector to match the setting on a
single remote switch. This will enable you to
easily turn off the power to multiple devices
connected to multiple surge protector units
within range.*
PROdUCt featUReS
.
2 Always-On Outlets
Suggested use with the following
devices:
-
Wireless Routers
-
Modems
-
Cordless Phones
-
Digital Video Recorders (DVRs)
.
6 Remote-Switched Outlets (Switch ON
and OFF in response to remote switch)
Suggested use with the following
devices:
-
Computers
-
Monitors
-
Printers
-
Computer Speakers
-
External Hard Drives
-
Paper Shredders
-
Lamps
.
Resettable circuit breaker
.
“Not Grounded” light to indicate when a
ground is not present
.
“Always-On Outlets” light to show when
power is present
.
“Remote-Switched Outlets” light to show
when switched outlets are active
.
Manual override button to control
switched outlets
.
Conserve has a range of up to 60 feet.*
Line of sight from the wireless remote
switch to the Surge Protector is not
required.
