ENGLISH
Belinea 1945 G1 - Operating Instructions - 3
MOUNTING
Mounting on the base
Only remove the safety pin from the back of
the base, if the monitor stands firmly on the
base.
Insert the shaft into the base until it locks in.
Wall mounting
The monitor is shipped with the standard desktop
configuration. However, you can optionally mount the
device on a wall or on a monitor swivel arm (optional
accessory). For mounting remove the screws from
the back of the monitor (4 screws). Use a VESA com-
patible support (4-hole assembly of 100 x 100 mm ac-
cording the international VESA FDMI standard) and
follow the corresponding instructions.
CONNECTION
1 Make sure that the monitor and the PC are
disconnected from the mains supply.
Connecting to an analogue graphics
card
You can connect the monitor to an analogue graphic
board or to a digital graphics card.
Connect the plugs carefully in order not to
bend the pins.
1 Connect the supplied signal cable to the socket D-
SUB.
2 Connect the other end of the signal cable to the
output socket of your graphics card.
Connecting to a digital graphics card
1 Connect the optional signal cable to the socket
DVI.
2 Connect the other end of the signal cable to the
output socket of your graphics card.
Audio connection
If you PC has a separate audio output, use the audio
cable to connect the monitor to the PC.
1 Connect the supplied audio cable to the socket
AUDIO IN.
2 Plug the other end of the audio cable into the
output socket on the PC.
Mains connection
1 Connect the supplied power cable to the socket
AC IN.
2 Plug the other end of the power cable into a
grounded wall outlet.
3 Reconnect your PC to the mains supply.
START UP
1 Switch your PC on.
2 Press the button [
] on the front of the monitor.
The status indicator beside the button [
] lights up
green or orange.
Green = monitor active
Orange = monitor on stand-by (power save mode).
DVI
VGA
D-SUB
DVI
AUDIO IN
AUDIO
