BELINEA 101830, Service Manual

Page: 10 / 85

10
OSD Lock/Unlock, Attention signal, Service Mode
Go to cover page
Front control panel
ATTENTION
OSD MAIN CONTROLS LOCKED
ATTENTION
OSD MAIN CONTROLS UNLOCKED
ATTENTION
ATTENTION SIGNAL OFF
ATTENTION
ATTENTION SIGNAL ON
To Lock/Unlock OSD function (User Mode)
The OSD function can be locked by pressing button for more than
10 seconds, the screen shows following windows for 3 seconds.
Everytime when you press or button, this message appears
on the screen automatically. The & (brightness) ,
(input) hotkey are still functional for brightness and input signal
selection while OSD locked.
Switch ON/OFF attention signals (User Mode)
All attention signals can be by keep pressing button
for more than 10 seconds if there is no video signal supplied.
Step 1: Disconnect signal cable (Monitor & PC are still ON.)
Step 2: Press "AUTO" button for more than 10 seconds, bring up
message as below.
switched off
Recover attention signals by pressing button for more than 10
seconds without video signal input.
Step 1: Disconnect signal cable (Monitor & PC are still ON.)
Step 2: Press "AUTO" button for more than 10 seconds again,
bring up message as below.
Access Service Mode (in USER MODE)
Method 1:
Leave service mode by either re-feed video signal or simply turn off
and on the power of monitor.
Step 1: Disconnect signal cable on Rear side of monitor.
Don't disconnect signal cable on PC side, because CPU will
detect pin-9 of D-SUB (15 pin connector).
(Monitor & PC are still ON.)
Bring up "CHECK CABLE CONNECTION" screen.
Step 2: Press MENU" " button for more than 15 seconds.
Bring up message as below.
Access Service Mode (in USER MODE)
Method 2:
Leave service mode by either re-feed video signal or simply turn off
Step 1:
- Turn off monitor.
- Disconnect signal cable on PC side.
- Turn on monitor.
(After 3 seconds)
Bring up "NO VIDEO INPUT"
Step 2: Press MENU" " button for more than 15 seconds.
Bring up "SERVICE MODE".
Access Service Mode (in USER MODE)
Method 3:
Leave service mode :simply turn off and on the power of monitor.
Step 1:
- PC off.
- Signal cable connect to rear side of Monitor only.
- Turn on monitor.
Bring up "NO VIDEO INPUT"
Step 2: Press MENU" " button for more than 15 seconds.
Bring up "SERVICE MODE".
AUTO
AUTO
AUTO
MENU
MENU
Locked OSD function can be released by pressing button for
more than 10 seconds again. While press "MENU" button for OSD
unlocked purpose, the screen will keep showing OSD MAIN
CONTROLS LOCKED u ntil OSD function unlocked and screen
automatically shows following window for 3 seconds.
MENU
1 = Buttons for the OSD menu (On-Screen-Display)
2 = Power indicator
3 = Power button
2 3 1
AUTO MENU INPUT
INPUT
ATTENTION
CHECK CABLE CONNECTION
ATTENTION
NO VIDEO INPUT
ATTENTION
NO VIDEO INPUT
MENU
MENU
SERVICE MODE
SERIAL NO. : YEKA105542
HOURS OF OPERATION: 000222
MENU
SERVICE MODE
SERIAL NO. : TW211P0022
HOURS OF OPERATION: 000205
SERVICE MODE
SERIAL NO. : TW211P0022
HOURS OF OPERATION: 000205
Max 101830