Miscellaneous parts
Should they be needed, Belimo carries a range of parts. Ball joints and 5/16” rods
are available from most distributors.
KH8
KG8 3/8”
KG6, KG10A ¼”
SH8
(not shown – see picture page 9). Push-rod for KG6 & KG8 ball joints. 5/16” 36” long
Use SH10 3/8” rods for GMB and dual FSAF or FSNF linkages. 5/16” can bend under heavy loads.
ZG-DC1
Damper blade clip and ball joints for blades typically 3.5” in
width. Typically the actuator or rod to shaft is in front
of blade.
ZG-DC2
Damper blade clip and ball joints – typically used for 6” wide
blade control dampers. Typically the ctuator or rod to shaft is
above or below the damper.
KH-6. Zinc plated steel. For shafts 3/8” to 11/16”
Uses KG6 ball joint. Slot width 1/4”
KH-8. Zinc plated steel. For shafts 3/8” to 11/16”
Uses KG8 (90 degree) or KG10A ball joint. Slot
width 21/64”
Where the crank arm on the jackshaft is broken or
not of the type needed, the KH12 fits over the
shaft without removing it. Zinc plated steel. Slot is
for the KG10A ball joint. V-bolt fits ¾” to 1” (20 to
25mm) shafts.
Safe-Air Honeywell ML & MS Motors with Belimo FSNF120 Series March 2018
15
