3
KMV-3901/3911
Quick Start Guide
In addition to the above, you will need the following (not supplied):
• Up to 2 displays
• A dedicated 100Base-T Ethernet switch with enough ports for the KMV-3901/3911,
client PCs, and Kaleido-RCP2 units
• Client PC (see below for system requirements)
• Cables (to connect your multiviewer to video sources, to displays, and to the network):
System Requirements for a Client PC
A client PC running Windows XP (or Windows 7) is required to access the XAdmin Web
client, as well as to run the XEdit application.
Step 1: Physical Setup
Cable type
Purpose
CAT-5
For Ethernet connectivity
Display cables
Either extension modules—for example Miranda’s DXF-200 (part
number DXF-200-C)—or standard HDMI cables (non-locking)
Video cables
Standard coaxial cables with BNC connectors
Notes
• On all Miranda multiviewers, the network adapters are set to auto-
negotiate. By default, the connection speed and duplex mode will be set
automatically based on the corresponding port settings on the switch.
• If you have two displays, make sure the HDMI connectors on the
multiviewer side have the same dimensions. Otherwise, the multiviewer’s
built-in locking mechanism will not be able to secure the smaller of the
two connectors. You may order suitable HDMI cables from Miranda—
HDMI to DVI female cable (1ft), part no. KXC-HDMI-DVI.
Minimum configuration 1 GB of RAM
Pentium 4 at 1 GHz
Recommended
At least 2 GB of RAM
Core 2 Duo at 2 GHz, or better
Hard disk
At least 125 MB free
IMPORTANT
Make sure the KMV-3901/3911 cards are NOT connected to the network
To avoid IP-address conflicts during this initial physical setup make sure none
of the multiviewer cards are connected to the network—i.e. make sure there
is no cable connected to your cards’ ETH port—before powering up the
Densité frame.
