39
Densité 3+ FR1
User Manual
Menu for local control
The REF-1801-FR1 has operating parameters which may be adjusted locally at the
controller card interface. After pressing the
Select
button on the REF-1801-FR1 module, use
the keys on the local control panel to step through the displayed menu and adjust the
parameters. The menu is shown below.
STATUS
REFERENCE
SOURCE
[ AUTO, EXTERNAL, INTERNAL ]
URS GEN MODE
[ NORMAL, FREERUN ]
TIME CODE
SOURCE
[ AUTO, LTC, VITC, OFF ]
PROCESSING MODE
[ NORMAL, PASS THROUGH ]
USER BITS
[ OFF, ON ]
CONFIG ALARMS
NO INPUT SIGNAL
ALARM LEVEL
[ GREEN, YELLOW, RED, FLASH RED ]
ALARM REPORT [ NONE, GPI ]
NO TIME CODE
ALARM LEVEL
[ GREEN, YELLOW, RED, FLASH RED ]
ALARM REPORT [ NONE, GPI ]
VERSION
MAJ.MIN.Number.Build
FACTORY DEFAULT
RESTORE
Status LED
The status monitor LED is located on the front card-edge of the REF-1801, and is visible
through the front access door of the Densité frame. This multi-color LED indicates module
status by color, and by flashing/steady illumination, according to the chart below. The chart
also indicates fault reporting for this card on the Densité frame’s serial and GPI interfaces.
Fault
Serial
Report
GPI
Report
Green
Yellow
Red
Flashing
Red
Mode Freerun
No Signal
I/O Mismatch
No Time Code
Hardware failure
: Factory default.
A
Flashing Yellow
Status LED indicates that the
SELECT
button on the front panel has been
pushed.
Remote control using iControl
The operation of the REF-1801-FR1 may be controlled using Grass Valley’s iControl system.
• This manual describes the control panels associated with the REF-1801-FR1 and their
use.
