44
Installation RSR20/RSR30
Release 06 07/2021
2.4.2
Supply voltage with the characteristic value C
You will find information on the characteristic values here:
“Combination options RSR20/RSR30” on page 19
Figure 8: Supply voltage with characteristic value C: 2 pin terminal block with screw
lock
The supply voltage is connected via pin 1 and pin 2.
For
every
supply voltage to be connected, perform the following steps:
Remove the terminal connector from the device.
Connect the wires according to the pin assignment on the device with the
clamps.
Fasten the wires in the terminal block by tightening the terminal screws.
With a non-redundant supply of the supply voltage, the device reports the
loss of a supply voltage. You can prevent this message by changing the
configuration in the Management.
2.4.3
Signal contact
Proceed as follows:
Connect the signal contact lines with the terminal block connections.
Fasten the wires in the terminal block by tightening the terminal screws.
Type of the voltages that
can be connected
Specification of the supply
voltage
Pin assignment
DC voltage
Rated voltage range DC:
24 V DC ... 48 V DC
Voltage range DC incl. maximum
tolerances:
18 V DC ... 60 V DC
+
Plus terminal of the supply
voltage
−
Minus terminal of the
supply voltage
Table 19: Supply voltage with characteristic value C: type and specification of the
supply voltage, pin assignment on the device
−
+
Summary of Contents for HIRSCHMANN RSR20 Series
Page 66: ......
