Belden Hirschmann RED25 Series, User Manual

Page: 17 / 40

Installation RED25
Release 01 02/2015
17
1.4 Power supply
A 6-pin, screwable terminal block is available for the redundant supply to the
device.
For further information see “Supply voltage” on page 25 .
1.5 Ethernet ports
1.5.1 10/100 Mbit/s twisted pair port
The 10/100 Mbit/s twisted pair port offers you the ability to connect network
components according to the IEEE 802.3 10BASE-T/100BASE-TX standard.
This port supports:

Autocrossing (if autonegotiation is activated)
 Autonegotiation
 Autopolarity
 10 Mbit/s half-duplex mode, 10 Mbit/s full duplex mode

100 Mbit/s half-duplex mode, 100 Mbit/s full duplex mode
Delivery state: autonegotiation active
The socket housing is electrically connected with the front panel.
The pin assignment corresponds to MDI-X.
9 Locking gate for removing the device
10 MAC address of device (label)
11 Label area for IP address of device
Pin Function
1 RD+ Receive path
2 RD − Receive path
3 TD+ Transmission path
6 TD − Transmission path
4,5,7,8 —
Table 8: Pin assignment of the 10/100 Mbit/ twisted pair port, RJ-45 socket, MDI-X
mode
Table 7: Front view:
on the left: Device variants RED25-04002T1TT-.DD....E2S.......
on the right: Device variants RED25-04002Z6TT-.DD....E2S.......
1
2
3
4
5
6
7
8