Configuration
4.3 Mobile WAN Configuration
4.3.7 Examples of SIM Card Switching Configuration
Example 1: Timeout Configuration
Mark the
Switch to default SIM card after timeout
check box, and fill-in the following values:
Figure 22: Configuration for SIM card switching Example 1
The first attempt to change to the default SIM card is carried out after 60 minutes. When the
first attempt fails, a second attempt is made after 30 minutes. A third attempt is made after 50
minutes (30+20). A fourth attempt is made after 70 minutes (30+20+20).
Example 2: Data Limit Switching
The following configuration illustrates a scenario in which the router changes to the second
SIM card after exceeding the data limit of 800 MB on the first (default) SIM card. The router
sends a SMS upon reaching 400 MB (this settings has to be enabled on the
SMS Configuration
page). The accounting period starts on the 18th day of the month.
Figure 23: Configuration for SIM card switching Example 2
4.3.8 PPPoE Bridge Mode Configuration
If you mark the
Enable PPPoE bridge mode
check box, the router activates the PPPoE bridge
protocol. PPPoE (point-to-point over ethernet) is a network protocol for encapsulating Point-to-
Point Protocol (PPP) frames inside Ethernet frames. The bridge mode allows you to create a
PPPoE connection from a device behind the router. For example, a PC connected to the ETH
port of the router. You assign the IP address of the SIM card to the PC. The changes in settings
will apply after clicking the
Apply
button.
52
UM Configuration OWL LTE M12
Rel. 06.1.09 - 07/2019
Summary of Contents for Hirschmann OWL LTE M12
Page 153: ......
