60
Installation BAT-R
Release 17 12/2020
10.2
Dimension drawings
Figure 5: Dimensions of device variants featuring supply voltage with characteristic
value W (24 V DC)
Note: figure without connections
Signal contact
“FAULT”
Switching current
max. 1 A SELV according to IEC 60950-1
or ES1 according to IEC/EN 62368-1
Switching voltage
Supply voltage with characteristic value C
(24 V DC ... 48 V DC) and K (60 V DC ...
250 V DC / 110 V AC ... 230 V AC, 50 Hz ...
60 Hz):
max. 60 V DC or max. 30 V AC SELV
according to IEC 60950-1 or ES1 according
to IEC/EN 62368-1
Supply voltage with the characteristic
value W:
max. 30 V DC, SELV according to
IEC 60950-1 or ES1 according to IEC/
EN 62368-1
Pollution degree
2
Protection classes Laser protection
Class 1 in compliance with IEC 60825-1
Degree of protection
IP20
a. As an alternative to the back-up fuse is possible:
Supply voltage based on Limited Power Source, NEC Class 2 or PS2 according to IEC/
EN 62368-1 AND maximum output power <100 W
b. As an alternative to the back-up fuse is possible:
Supply voltage based on Limited Power Source, NEC Class 2 or PS2 according to IEC/
EN 62368-1 AND maximum output power <100 W
c. Temperature of the ambient air at a distance of 2 in (5 cm) from the device
d. Use SFP transceivers with the “EEC” extension only, otherwise the standard temperature
range applies.
120,6 mm
145 mm
136,4 mm
120,8 mm
4.75 in
5.71 in
4.76 in
5.37 in
