Belden Hirschmann MIPP, Description And Assembly Instructions

Page: 16 / 26

16
MIPP
Release 01 01/12
2.2.2 Installation of installation cables on LC and SC
modules
Proceed as follows:

Loosen the cable gland.

Guide the installation cable through the cable gland in the module.

Remove the jacket from the installation cable to a sufficient length for
termination.

When using a double module: Install 12 fibers on both sides.

Tighten the cable gland.

Fix the strain relief.
Note:
Follow the safety instruction from the splicer manufacturer.
Note:
When performing fusion splicing, we recommend you to use heat
shrink protectors with a diameter of 1.3 mm after shrinkage and a length of
25 to 35 mm.
Note:
When performing mechanical splicing, we recommend you to use
crimp splice protectors with a width of 1.3 mm and a length of 25 to 35 mm.

A) Splice the pigtails to the fibers of the installation cable and fix the splice
position in the splice holder.
Or:
B) Terminate the fibers with the Brilliance connectors.

Place the fiber into the fiber bracket.
Note:
The module has space for a maximum of 15 m of fiber supply.

Insert the connectors into the adapters until it locks into place.
2.2.3 Installation of installation cables on CU modules
Proceed as follows:

Install the installation cables into the RJ45 Keystone jacks (see product
documentation from the Keystone jacks manufacturer).

Press the Keystone jacks into the cutout in the module until it locks into
place, beginning with cable 3, and continuing with cable 4, then cable 2
and finally cable 1
(see fig. 17 “Cables arrangement – Top view”) .