Belden Hirschmann EAGLE20, User Manual

Page: 40 / 60

40
Installation EAGLE20/30
Release 11 09/2020
3.1 First login (Password change)
To help prevent undesired access to the device, it is imperative that you
change the default password during initial setup.
Perform the following steps:

Open the Graphical User Interface, the Command Line Interface, or
HiView the first time you log on to the device.

Log on to the device with the default password “private”. The device
prompts you to type in a new password.

Type in your new password.
To help increase security, choose a password that contains at least 8
characters which includes upper-case characters, lower-case characters,
numerical digits, and special characters.

When you log on to the device with the Command Line Interface, then the
device prompts you to confirm your new password.

Log on to the device again with your new password.
Note: If you lost your password, then use the System Monitor to reset the
password.
For further information see:
https://hirschmann-support.belden.com/en/kb/required-password-change-
new-procedure-for-first-time-login