7: Administration
UM Configuration BAT-C2
147
Release 01.0.00 04/2019
Quick Setup
Quick Setup provides a place to configure all basic settings in one place. You may access Quick
Setup through the Administration menu or whenever you reset your system to factory defaults.
Note:
The “Installation User Manual” provides for instructions on accessing Web
Manager via SoftAP. The “Installation User Manual” can be found as PDF download on
the Internet at the Hirschmann product pages (
Setting
Description
State
Select to enable or disable the state
Transparent Mode
Select to enable or disable the transparent mode.
Network Access for
Gateway
Select to enable or disable network access for the gateway.
Ethernet Interface
Select the desired interface.
Bridging MAC Address
Enter the bridging MAC address
Bridging IP Address
Enable
Auto Detect IPv4 Address
or disable it to enter the bridging IP address.
Check the appropriate radio button to enable or disable. If enabled, the BAT-C2
will attempt to learn the IP Address by using the source or destination IP address
of packets arriving on the Ethernet interface. This may affect the performance of
running processes during the learning phase.
Bridging IP Address
Select to enable or disable auto-detection of the IPv4 address.
Bridging IPv6 Address
Enter the bridging IPv6 address
Initial Scan Interval
Enter the
Initial Scan Interval
in seconds.
Scan Interval
Enter the
Scan Interval
in seconds.
Table 7-34 Bridge 1 (br0) Configuration
Setting
Description
WPS (PBC)
Click this button for push button connect.
WPS (PIN)
Click this button for pin hole connect.
Table 7-35 Wi-Fi Protected Setup
Setting
Description
Network Name (SSID)
View existing network name/SSID, if any.
State
Select to enable or disable the state.
IPv4 State
Select to enable or disable the state.
DHCP Client
Select to turn on or off.
IPv6 State
Select to enable or disable the state.
IPv6 DHCP Client
Select to turn on or off.
IPv6 Auto
Configuration
Select to turn on or off.
Table 7-36 Current Configuration
Setting
Description
Refresh scan results
every 60 seconds
Check this checkbox and click
Scan
to scan available networks every 60 seconds.
Scroll through list of available networks listed, as desired.
Table 7-37 Available Networks