Belden Grass Valley XCU Universe XF, User Manual

Page: 39 / 66

XCU Universe XF XF Transmission Base Station User’s Guide (v1.4) 39
Chapter 5 - XCU menu reference
5.3 Audio/Intercom menu
Menu item Settings Default Level Description
Audio
Audio 1 Level 0dB, 6dB 6dB User 1 Selects studio attenuation level for Audio input 1
Audio 2 Level 0dB, 6dB 6dB User 1 Selects studio attenuation level for Audio input 2.
Intercom
Source Analog, IP Analog User 1 Selects source for Intercom:
Analog = from back panel XCU intercom connector;
IP = from the IP Media Network
Isolate
Isolate Isolate, System System User 1 Isolate = disconnects Program and Production
intercom channels from camera head;

System = isolate is off
Eng
Wire Mode 4wire, 2wire 4wire User 1 Selects wiring mode for Engineering (Eng) intercom
channel.
Volt/Cur drive 4wire, 2wire 4wire Service <Advanced settings>
2/4 wire 4wire, 2wire 4wire Service <Advanced settings>
Level 0dB, 6dB 6dB User 1 Selects intercom channel attenuation (only available
in 4wire mode, in 2wire mode level is always 0 dB).
Side Tone 0..99 50 User 1 Sets side tone (feedback) volume level.
Prod
Wire Mode 4wire, 2wire 4wire User 1 Selects wiring mode for Production (Prod) intercom
channel.
Volt/Cur drive 4wire, 2wire 4wire Service <Advanced settings>
2/4 wire 4wire, 2wire 4wire Service <Advanced settings>
Level 0dB, 6dB 6dB User 1 Selects intercom channel attenuation (only available
in 4wire mode, in 2wire mode level is always 0 dB).
Side Tone 0..99 50 User 1 Sets side tone (feedback) volume level.
Prog
Wire Mode 4wire, 2wire 4wire User 1 Selects wiring mode for Program intercom channel.
Level 0dB, 6dB 6dB User 1 Selects intercom Program (Prog) channel attenuation
(only available in 4wire mode, in 2wire mode level is
always 0 dB).