7
Vertigo XG
Installation and Quick Start Guide
Rear Panel Components
The Vertigo XG’s rear panel provides convenient access to the video card’s I/O connector,
which provides 4 SD/HD SDI video outputs, a reference signal input, and AES audio
input/output. The rear panel also provides access to the graphics card connector, as well as
various I/O ports (RS-422, USB, Ethernet...etc.).
Fig. 2-1: The Vertigo XG’s rear panel components (XG22-e model)
Power Supply Modules (2)
RS-422 Connectors
USB 2.0
Network Ethernet
Connectors (2)
SDI Video Card
Connectors (4)
I/O Connector
Graphics Card
System Fans (2)
Serial
RS-232 Ports (2)
Mouse
Keyboard
Connectors
(option)
Audio I/O Ports
(Disabled)
Discrete Audio
Connectors (2)
(option)
Connector
Connector
GPI Card Connector
(option)
Time Code
Card
LTC
IN
LTC
IN
Note: In some cases, the positioning of the connectors on the Vertigo
XG’s rear panel differs depending upon the hardware options
installed. See
for a list of the Vertigo XG’s hardware options.
Mouse & Keyboard
connectors
The two (2) PS/2 connectors on the rear panel allow you to connect a
mouse and keyboard to the Vertigo XG device. These peripherals are
required during the device’s initial configuration, which involves
using the Vertigo XG’s desktop applications, including Dashboard.
Note that if the mouse or keyboard has a UBS connector, you can
connect them to the USB 2.0 connectors on the front or rear panels
of the Vertigo XG device.
USB 2.0 Connectors
The four (4) USB 2.0 connectors on the rear panel allow you to
connect peripheral devices (e.g. keyboard, mouse, flash drive...etc) to
the Vertigo XG.
Summary of Contents for grass valley VERTIGO XG
Page 12: ...xii Table of Contents...
Page 14: ...2 Introduction...
