Belden GRASS VALLEY NV9640A, User Manual, Page: 24 / 112

14
Configuration
Configuration
Adding a Panel to an NV9000 Configuration
You must create configurations for the NV9640A using NV9000-SE Utilities. We assume that you
are familiar enough with NV9000-SE Utilities that you can understand the following material. It
is not difficult material, but some of the concepts might not be familiar to everyone.
It takes only a few seconds to add a new panel configuration.
After launching NV9000-SE Utilities, choose ‘Control Panels’ from the Configuration pane in the
navigation area. The ‘Control Panels’ configuration page appears:
Click ‘Add Control Panel’ at the bottom of the configuration page. The ‘Add Control Panel’ page
appears:
Choose “NV9640” from the ‘Type’ field. In the ID field, enter the panel ID you assigned to the
panel while it was in setup mode. Give a name to the panel in the name field and select a user.
 The NV9640A and the NV9640 use the same configurations.
When you are creating a panel configuration you have 3 options. These options are presented in
the ‘Configuration Options’ area: