102
System Configuration
Network Settings Panel
Network Settings Panel
KMX-3921 cards are shipped with default network settings, which you must replace with
values suitable for your network environment. You may need to consult your network
administrator to get the correct values. Enter the appropriate IP address, mask, and
gateway information to configure a KMX-3921 card so that it can work with your Ethernet
network. For a multiviewer system that has three, four, or six KMX-3921 cards, this panel is
not available for the third, fourth, and sixth cards.
Click
Apply
to set these values into the card, or
Cancel
to leave the original values
unchanged.
Options Panel
The Options panel is used to enable software options that are not part of the basic offer.
Software options are enabled by entering a software key that has been sent to you once
you have purchased the option. See the
Available Hardware and Software Options
page 120 for a list of available options and their corresponding part numbers.
To activate an option, see
Notes
• These settings apply to the
CONTROL PORT ETHERNET
ports at the back of
the
Densité 3+ FR1 / Densité 3+ FR4
frame.
• Network adapters are set to auto-negotiate. By default, the connection
speed and duplex mode will be set automatically based on the
corresponding port settings on the switch.
• A Densité 3+ FR4 frame can require more than one MAC address which
could cause connectivity problems with certain network switch
configurations. See
, on page 58 for more
information.
