Belden Grass Valley Kayenne K-Frame, Installation & Service Manual

Page: 124 / 288

124 KAYENNE K-FRAME — Installation & Service Manual
Section 5 — Basic Configuration
See Menu Panel Registration on page 128 regarding additional configuration
steps required.
Setting 32-Crosspoint Remote Aux Panel IP Address
The default IP addresses of Remote Aux Panels are set to at the factory
before shipment will not work with a Kayenne K-Frame system whose
other components are set to defaults. Typically, Kayenne K-Frame systems
are equipped with more than one Remote Aux Panel. If more than one
Remote Aux Panel will be used on your Kayenne K-Frame system, you will
need to change each panels’ IP addresses so none are duplicated, and this
must be done before you connect them to the network. This will require a
mouse and keyboard connected to a PC disconnected from the network.
Check with your network administrator to learn what IP addresses should
be used at your facility.
Setting the IP Address
A PC equipped with an Ethernet interface and a web browser is required to
change Remote Aux Panel IP addresses.
1. With the PC disconnected from all facility networks, connect the PC’s
Ethernet port directly to the Remote Aux Panel.
Note A crossover Ethernet cable (Tx/Rx pair crossed) is needed when connecting
a PC directly to the Remote Aux Panel without a hub intermediary.
2. Start the web browser, enter the default IP address (192.168.1.2) in the
address field, and press
Enter
. If the address is found, a Panel Status
screen swill appear.
Note If the Remote Aux Panel address is not found, you may need to reset the
panel to its defaults (see
page 127 ).