Belden Grass Valley KALEIDO-X16, Installation & Service Manual

Page: 101 / 152

101
Kaleido-X16
Hardware Description & Installation Manual
PSU slot locations
Two PSUs installed in a frame; front cover removed
Removing a Power Supply
To remove a power supply
1 Open the front cover of the frame and locate the power supply (PSU) you would like to
remove (either the left or the right side).
2 Pull on the handle on the right side of the PSU and pull the PSU out of the frame.
Installing a Power Supply
To install a power supply
1 Position the power supply (PSU) in front of an empty power supply slot in front of the
frame, with the connector end towards the frame and the PSU handle on the right side.
2 Slide the PSU into the empty slot, moving it gently until it contacts the sockets at the
rear of the slot.
3 Push firmly but gently on the PSU faceplate until the PSU’s connectors have mated with
the frame's sockets, and the PSU will go in no further.
Slot A Slot B PSU A removed from Slot A