Belden Grass Valley Kaleido-X, Installation & Service Manual

Page: 83 / 216

83
Kaleido-X (7RU)
Installation & Service Manual
Control
The connectors located in the middle of the rear panel are control connectors. The
following table lists the purpose of each control connector.
GPI/Genlock Rear Panel Connections
External connections to the GPI/Genlock card are made through connectors mounted on
the KXA-GPI-GEN-R rear panel. These connectors carry both input and output signals.
ANALOG OUT 1 L ANALOG OUT 2 L WECO Analog audio output (left channel) to feed
the audio monitoring system
ANALOG OUT 1 R ANALOG OUT 2 R WECO Analog audio output (right channel) to
feed the audio monitoring system
AES OUT 1 AES OUT 2 WECO Digital audio output (AES) to feed the audio
monitoring system
OPTION 1 OPTION 2 RJ-45 For future use
Connector label Connector type Function
LTC IN 1 BNC Time code input #1
LTC IN 2 WECO Time code input #2
LTC IN 3 WECO Time code input #3
ETHERNET RJ-45 100 Base-T Ethernet connection
USB USB A Connect a mouse, keyboard, or USB key for Kaleido
Software upgrade or data backup
There are three other USB ports accessible on the front of
the card that serve the same functions.
RS-422 RJ-45 (see note
below) Connect to an RS-422 (SMPTE ST 207, EBU-3245) or
RS-485 device or network
Note:
The Kaleido-X’s RS-422 ports have an RJ-45 connector in order to
preserve space on a busy panel. The RS-422 interface specifies a DE-9
connector, so if you are using this interface, you will require a DE-9-to-RJ-45
adapter. Grass Valley supplies two adapter models, correctly wired for this
application: a straight adapter (part no. 1737-3000-102), and a crossover
adapter (part no. 1792-3700-100). See
RS-422 Connection Diagram , on
page 214 for the RS-422 pinout specification.
Connector label
Connector
type
Function Head 1 Head 2
Bottom of panel Top of panel