Belden Grass Valley Kaleido-X, Installation & Service Manual

Page: 82 / 216

82
Multiviewer Cabling
Signal Connections to the Multiviewer
Signal Connections to the Multiviewer
KXO-Dual Output Rear Panel Connections
HD-SDI Monitoring Output Option
The output cards provide support for HD-SDI monitoring output in 720p, 1080i or 1080p
(available with the optional KXO-HDM mezzanine).
• KXO-Dual: If the KXO-HDM mezzanine is installed on a KXO-Dual card, the only HD-SDI
output formats supported are 720p and 1080i.
• KXO-Dual3: For a KXO-Dual3 card, the scan format is set with the associated displays’
configuration, in XEdit. Refer to the Rooms chapter, in the Kaleido Software User’s
Manual. See
Related Documentation , on page 15, for details.
Rear Panel Connections
The rear panel layout is divided into three areas: Head 1, Head 2, and Control.
When the rear panel is horizontal and you can read the connector labels normally, the
connectors located at the right-hand side are the
Head 1 connectors and the connectors
located at the left-hand side are the Head 2 connectors
The following table lists the function of each output head connector.
Note:
To install a KXO-HDM mezzanine on an existing KXO-Dual or KXO-
Dual3 card, refer to the KXO-HDM Installation Instructions , for details.
See
Related Documentation
, on page 15
Connector label
Connector
type
Function Head 1 Head 2
HD/SD SDI OUT 1 HD/SD SDI OUT 2 BNC Serial digital HD output signal for
monitoring purposes
DVI IN 1 DVI IN 2 DVI DVI input signal that can be used as a
background in the monitor wall display in
place of the internally-generated
background
DVI-D OUT 1 DVI-D OUT 2 DVI DVI digital output (no analog signal on this
connector)
RGBHV OUT 1 RGBHV OUT 2 DE-15S High-resolution analog component output
to feed the monitor wall display
Bottom Top
Head 2 Control Head 1