Belden Grass Valley Kaleido-X, Installation & Service Manual

Page: 34 / 216

34
Installation
Mechanical Installation
Front Card-Edge Layout
A single LED status indicator is visible on the front edge of the card:
The Reset button is located on the front card edge of the KXO-24Router card. Its function is
to reset the FPGA and restart the card. This function is for maintenance use only.
An ICAT connector is located on the front card edge at the bottom below the RESET button.
This connector is reserved for factory use, and has no user functionality.
Mechanical Installation
Rack-Mount Installation
A Kaleido-X multiviewer can be installed in a standard 19-inch rack, using the appropriate
screws and washers (not included). The Kaleido-RCP2 Remote Control Panel (optional) may
also be installed in a rack using the optional KRCP-RK2 mounting kit.
Locate the multiviewer where it will receive proper ventilation. Make sure the front and side
panel air vents are not blocked and the air filter is clean. See
Ventilation , on page 37.
LED label LED color Interpretation
Card Status Green OK
Red Configuration failed
Flashing Red System upgrade in progress
Status LED
Reset button