Belden GRASS VALLEY KALEIDO Series, Installation & Service Manual, Page: 82 / 128

82
System Configuration
Testing the Monitor Wall’s Operation
Testing the Monitor Wall’s Operation
The Kaleido - IP software must be activated through a license before a layout can be shown
on the monitor wall. When the monitor wall shows the message The Kaleido - IP software
license is not activated. Please enable the license via XAdmin to be able to display a layout , see
Available Hardware and Software Options , on page 75 for information about the required
Kaleido - IP activation license ( KIP-OPT-ACTIVATION ) and Enabling Options , on page 80 for
how to install the license.
If your system was configured prior to shipment, then a layout appears on all displays.
Otherwise, a gray screen will appear with the following message in the middle: No layout
has been assigned to this room. Please load a layout.
To load a layout on the monitor wall
• If you have configured a Kaleido-RCP2 (see Using a Kaleido-RCP2 with Default Settings ,
on page 73), press any of the LAYOUT PRESETS buttons to load a predefined layout on
the monitor wall.
• Alternatively, connect a mouse directly to one of the Kaleido - IP frame’s USB ports. See
Troubleshooting with the Kaleido - IP frame’s USB ports , on page 114 for more
information about this.
a Right-click anywhere on the monitor wall, point to Monitor Wall (if you clicked a
monitor), and then click Load layout on the shortcut menu.
A layout browser appears on the displays associated with the current room.
b Select the layout you want to load from the list of available layouts for this room,
and then click OK .
The selected layout appears on the room displays.
Note:
To access other layouts, press the LOAD button. To assign a layout to
a preset button, press and hold the button for more than six seconds while
the desired layout is showing on the monitor wall.