90
System Configuration
Cabling and Configuring the Head Streaming to support SMPTE ST 2022
-
7 Redundancy
5 Click Head streaming, in the navigation area on the left side of the page. See also
, on page 84 for more information.
The
Head Streaming Configuration
page appears.
6 Expand the streaming options section for the head you want to stream
SMPTE ST 2110
-
20 using SMPTE ST 2022-7 or not.
7 For SMPTE ST 2022
-
7 output redundancy, enable both
Enable streaming on LAN5 (A
Network)
and
Enable streaming on LAN6 (B Network)
.
8 Set the
Destination IP address
and
Port
number for both SMPTE ST 2110-20 network
streams:
LAN5 (A Network)
and
LAN6 (B Network)
. The
Destination IP addresses
are
Unicast and Multicast Sources and Destinations
Network mask
The appropriate network mask for this subnet. Use the same setting
as configured in the switch for each Kaleido
-
IP device’s network
ports.
Gateway
The IP address for the switch’s port interface to which the
Kaleido
-
IP’s media port is connected.
Parameter
Description
Summary of Contents for GRASS VALLEY KALEIDO Series
