Belden GRASS VALLEY KALEIDO-MX 1RU, Installation & Service Manual

Page: 129 / 164

129
Kaleido-MX (1RU)
Installation & Service Manual
For more information, refer to the Audio Bridge Terminal Guide to Installation and Operation ;
see Related Documentation , on page 17.
Verifying the Multiviewer’s IP Addresses and Application Version
Finding the System IP Address
To find your multiviewer’s system IP address
1 Press the Select button on the front edge of a Kaleido-MX output card. See KMX-3901-
OUT Front Card-edge Description , on page 32.
The Status LED on the selected card flashes orange, and the associated control menu
appears on the display of the Densité frame’s local control panel.
2 On the local control panel, press the [–] button repeatedly until NETWORK SETTINGS
appears on the display, and then press the SEL button. See Using the Densité Frame
Control Panel , on page 48 .
FRAME IP ADDRESS EDIT appears on the control panel’s display.
3 Press the SEL button again.
The current system IP address appears on the display. This is your system’s virtual
IP address (i.e., the address you will use to access your system from XEdit and XAdmin).
4 Press the Select button on the front edge of the output card to exit the control menu.
Verifying an Output Card’s IP Address and Application Version
To verify the IP address and application version on an output card
1 Press the Select button on the front edge of the Kaleido-MX output card. See KMX-
3901-OUT Front Card-edge Description , on page 32.
The Status LED on the selected card flashes orange, and the associated control menu
appears on the display of the Densité frame’s local control panel.
2 Note the position indication A or B in the card information shown on the first line of the
LCD display: either KMX-OUTA, or KMX-OUTB, followed with the slot number (e.g., KMX-
OUTA Slot 4).
3 On the local control panel, press the [–] button.
The version of the Kaleido Software that is running on the card (e.g. “8.40-build.987”)
appears on the display.
4 On the local control panel, press the [–] button repeatedly until NETWORK SETTINGS
appears on the display, and then press the SEL button.
FRAME IP ADDRESS EDIT appears on the control panel’s display.
Flashing red Upgrading firmware Red Hardware fault
Flashing red Upgrading firmware
ACTIVITY Indicator on Rear Panel Power-Supply LEDs on Front Panel
Color Status Color Status