Belden Grass Valley Kaleido-Modular-X, Hardware Description & Installation Manual

Page: 47 / 96

47
Kaleido-Modular-X
Hardware Description & Installation Manual
Replacing the Frame Controller Card
To replace a CPU-ETH2 frame controller
1 Open the front door of the frame (see Opening the front door , on page 40).
In a Densité 3 frame, the frame controller card is located to the right of the power
supply slots at the center of the frame.
• Hook your finger through the opening at the top of the card.
In a Densité 3+ FR1 frame, the frame controller card is located on the upper left-hand
side of the frame, above the left-hand power supply.
• Grasp the metal handle on the upper left-hand side of the card; the handle will
slide out so that it can be gripped properly.
2 Pull gently until the card is released from the rear connector, and then slide the card out
of the frame.
3 Slide the new card into the controller slot, and push gently on the card edge to engage
the rear connectors.
4 Be sure to close the front door before operating your Kaleido-Modular-X system, to
ensure proper ventilation (see Closing the front door , on page 41).
To replace a CPU-ETH3 frame controller
1 Open the front door of the frame (see Opening the front door , on page 40).
In a Densité 3+ FR4 frame, the frame controller card is located at the top center of the
frame.
2 Grasp the lever on the lower right-hand side of the controller beside the display, and
pull it straight out until it is fully extended.
Note:
Do not pull on the control panel to remove the card.