Belden Grass Valley KALEIDO-IP X110, Installation & Service Manual

Page: 27 / 110

27
Kaleido-IP X310/X110
Installation & Service Manual
Changing the Management IP Address from the Monitor Wall
The management IP address, system name, and other parameters can be set via a control
panel on the monitor wall, however this will also change the IP address of data interfaces.
To change the management IP address of the Kaleido-IP from the monitor wall
1 Connect a mouse to one of the USB connectors of the Kaleido-IP. See Troubleshooting
with the Kaleido-IP frame’s USB ports , on page 102 for more information about this.
2 Connect a keyboard to one of the USB connectors of the Kaleido-IP.
3 Right-click anywhere on the monitor wall, point to Monitor Wall (if you clicked a
monitor), and then click System configuration .
The System Configuration window appears.
4 Click the Ethernet tab.
5 Type the required management IP address, network mask, and gateway address in the
appropriate boxes.
6 Click OK .
7 When prompted to restart the system to apply your changes, click Yes .
8 Continue with the next procedure to set the IP address for the data networks.
Changing Network Settings in XAdmin
Once you have configured the management IP address from the monitor wall, use XAdmin
to configure an IP address for the network adapter that is connected to the
data network.
To change the Kaleido-IP’s management and data IP addresses
1 Configure your client PC with an IP address in the same range as the current
management IP address of the multiviewer (see Multiviewer Model Representation in
XEdit and XAdmin , on page 39).
2 Open a Web browser window and type your multiviewer’s management IP address in
the address bar.
3 The multiviewer’s home page appears.
4 Click the XAdmin button.
5 If you see a security warning, or a certificate error message, then see Registering your
Multiviewer's Security Credentials with your Browser , on page 51.
6 If the “Log in to XAdmin” page appears, type the password, and then click Log in .