Belden grass valley KALEIDO-IP VM, Quick Start Manual

Page: 10 / 28

8
Setting up the Kaleido-IP VM
Networking Setup
8 Click Apply settings .
The multiviewer must be restarted for changes to the network configuration to take
effect. A message appears, prompting you to reboot the system immediately.
9 Click OK .
Your Kaleido-IP VM restarts.
10 If this Kaleido-IP VM is meant to monitor HLS, RTSP, or RTMP sources, then you must
also configure access to your facilities’ DNS, and proxy servers:
a Click Configure , under DNS and proxy configuration .
The DNS and Proxy Configuration page appears.
b Type the appropriate suffixes for your primary domain, and search domain, and the
IP addresses for the primary, and secondary DNS server.
c Select Enable proxy , and then type the URL of the appropriate proxy auto-config
(PAC) file, if required.
d Click Apply configuration .
A message appears confirming that the changes have been applied.
e Click OK to dismiss the message.
11 If this system must monitor sources from a VLAN environment, then refer to Configuring
Virtual Network Adapters on a Kaleido-IP , in the Kaleido-X User’s Manual, to add the
required virtual network adapters.
12 If you need to change the head streaming settings, see Configuring Head Streaming ,
below.