GUIDE TO INSTALLATION AND OPERATION
SME-1901 / 1911 |
19
Multicast TS-over-UDP and TS-over-UDP/RTP
<protocol>://<source IP>@<multicast IP>:<port>
The <protocol> is either
udp
or
rtp
depending on the chosen Streaming Protocol. The <source IP>, if it is used, is
the card’s IP Address from the Network Settings panel. This will depend on the IGMP configuration in the network
equipment (switch or router). The <multicast IP> and <port> is the Main or Proxy IP Address and Port from the
Streaming Panel.
•
No IGMP
udp://@239.1.1.100:10000
rtp://@239.1.1.100:10002
•
IGMP Any Source Multicast (ASM)
udp://[email protected]:10000
rtp://[email protected]:10002
•
IGMP Specify Source Multicast (SSM)
udp://[email protected]:10000
rtp://[email protected]:10002
RTSP/TS-over-UDP/RTP and RTSP/TS-over-TCP
Main stream:
rtsp://<card IP>/hiProxy
Proxy stream:
rtsp://<card IP>/loProxy
The <card IP> is the card’s IP Address from the Network Settings panel.
During the RTSP session, the card will also send a Unicast/Multicast RTP stream to the destination located at the IP
Address from the Streaming Panel. If this is not required, set the IP Address to 0.0.0.0.
5.8 Network Settings panel
This panel sets up the IP address of this card on the
Ethernet.
IP Config
Type values directly into the data boxes for IP address,
Mask and Gateway.
•
Obtain the appropriate addresses from your IT
department as required.
If you have made changes, you must click
Apply
for the
changes to take effect, or
Cancel
to discard the changes.
Ethernet
Use the pulldown to select the speed of the ethernet
connection:
•
Autonegotiate
•
100 Base-TX FD [Full Duplex]
•
100 Base-TX HD [Half Duplex]
The status icon is green when the ethernet is connected.
Figure 5-11 Network Settings panel
