Belanger Top Wheel Mix & Match, Owner'S Manual

Page: 41 / 80

TOP WHEEL
Mix and Match
1MANUL749
Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681
37
Installation
Auto Retract Option Installation (if applicable)
Wiring for Optional Auto Retract
The information below covers the electrical connections required for proper operation of the Top
Wheel Optional Auto-Retract.
Upper Receiver
Brown + 340 (
24VDC
)
Blue - 338 (
DC COM
)
Black (
Signal
) X10
Lower Receiver
Brown + 340 (
24VDC
)
Blue - 338 (
DC COM
)
Black (
Signal
) X11
Upper and Lower Emitter
Brown + 340 (
24VDC
)
Blue - 338 (
DC COM
)
•
Wire the Pneumatic Retract Cylinder to
NAMED 6 Output Y20 or NAMED 7 Output
Y21
•
DO NOT run any of these wires through
the crossbeam
•
Once wired, confirm that both Auto-
Retract Upper and Lower inputs are ON
by verifying that the LE
D’ s of the Output
Board are ON
• Block each Receiver and confirm that the
correct Input turns OFF. Blocking Emitter
may not turn off Input
•
If the upper Auto-Retract Input does not
com ON, adjustment may be required. Do
so by loosening the Photo Eye tube on
the passenger side and rotate until Input
is ON and remains ON