TOP WHEEL
Mix and Match
10
Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681
1MANUL749
Introduction
Do
’s and Do Not’s
DO
DO NOT
Read all manuals carefully and
completely prior to beginning the
process the manual describes.
DO NOT drill in top of any electrical enclosures.
Verify that all parts needed to perform a step
described in the manual are present prior to
beginning the process.
DO NOT install high voltage and low voltage supply
lines in the same conduit.
Study and understand all installation diagrams and
drawings.
DO NOT operate machine until all safety features
are tested.
Carefully follow all instructions.
DO NOT attempt to add components to machine.
Use anti-seize lubricant on all threaded fasteners
(screws, bolts, nuts, etc.).
DO NOT substitute machine components.
Use quality thread sealant on all plumbing
connections to eliminate leaking.
DO NOT service without turning main
power off and following Lock-Out/Tag-
Out Procedures. Severe injury could
result.
Ask questions when they arise.
Check amperage draw on all motors (refer to motor
name plate).
Check all overloads are set correctly (refer to motor
name plate ratings and actual amp draw).
.
Check all electrical boxes are closed prior to spraying
water.
Check incoming electrical supply voltage to ensure it
matches equipment order.
Ensure all motor rotations are correct (observe
rotation arrow on motor).
Follow all maintenance schedules to ensure trouble-
free performance.
Periodically check all system stop circuits are
functional.
Table 1
Recommended General Practices to Do and Not Do when Installing, Maintaining, and/or Servicing Belanger® Equipment.
Summary of Contents for Top Wheel Mix & Match
Page 1: ...Top Wheel Mix Match 1MANUAL749 Rev12 Top Wheel Mix Match ...
Page 2: ......
Page 79: ......
Page 80: ......
