Belanger insta-KLEEN, Owner'S Manual

Page: 29 / 88

insta-KLEEN
™ MANUAL
1MANUL334
Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681
23
Installation
Optional Above-Ground Correlator
A Correlator is used to aid the driver in properly aligning the vehicle into the Guide Rails. It uses
rollers that allow the vehicle to easily move side to side and is complimented by the Belanger Y
Section to ease the transition even more.
The design of the Above Ground Correlator does not require any concrete work, which means
simple installation and easy maintenance for the operator. It does however require the Y-Section
to be installed and removed to determine the correct placement.
The following instructs you on how to install the Belan
ger “Above-Ground” Correlator.
You will
need to use the information in this document along with your site-specific drawings for a
successful installation.
Note:
If there is a need to extend the Correlator and Y-section to the outside of building, locate
the two 20” x 2” (508mm x 50.8mm) Y-section tube extensions. Cut to desired length. Butt
the tubing up against the exit end of the rails and weld into place. If this is the case
Correlators and Y-Section positions will change accordingly.
1) Locate the ten 5/16-18 x 1-1
/14” fasteners, 5/16” flat washers and the ten locking nuts. Secure the
ramps to the Correlator frames as shown below. The drive side requires 4 bolts and the
passenger side requires 6 bolts.
Note:
The Ramps should be flush with the top of the Correlator Frames.
41 ”
(1041.4mm)
41”
(1041.4mm)
31”
(787.4mm)