Belanger insta-KLEEN, Owner'S Manual

Page: 16 / 88

insta-
KLEEN™ MANUAL
10
Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681
1MANUL334
Introduction
Do
’s and Do Not’s
DO DO NOT
Read all manuals carefully and
completely prior to beginning the
process the manual describes.
DO NOT drill in top of any electrical enclosures.
Verify that all parts needed to perform a step
described in the manual are present prior to
beginning the process.
DO NOT install high voltage and low voltage supply
lines in the same conduit.
Study and understand all installation diagrams and
drawings. DO NOT power-up controller without following
manual.
Carefully follow all instructions.
DO NOT operate machine without testing all
sensors for clearance and operation.
Use anti-seize lubricant on all threaded fasteners
(screws, bolts, nuts, etc.). DO NOT operate machine until all safety features
are tested.
Use quality thread sealant on all plumbing
connections to eliminate leaking.
DO NOT service high- or low-pressure
pumps without turning main power off
and
following Lock-Out/Tag-Out
Procedures. Severe injury could result.
Ask questions when they arise.
DO NOT service without turning main
power off and following Lock-Out/Tag-
Out procedures. Severe injury could
result.
Check amperage draw on all motors (refer to motor
name plate). DO NOT attempt to add components to machine
without first contacting Belanger® Authorized Rep.
Check all overloads are set correctly (refer to motor
name plate ratings and actual amp draw). DO NOT substitute machine components without
first contacting Belanger® Authorized Rep.
Check all electrical boxes are closed prior to spraying
water.
DO NOT replace fuses with oversized fuses. Refer
to the fuse replacement chart located inside of the
enclosure.
Check incoming electrical supply voltage to ensure it
matches equipment order.
Ensure all pump and motor rotations are correct
(observe rotation arrow on pump/motor).
Follow all maintenance schedules to ensure trouble-
free performance.
Periodically check all system stop circuits are
functional.
Table 1
Recommended General Practices to Do and Not Do when Installing, Maintaining, and/or Servicing Belanger® Equipment.