Beko WDIC752300F2, User Manual

Page: 33 / 52

33 / EN
Washer-Dryer / User’s Manual
Select Additional Water or Extra Rinse
auxiliary functions. Use Cottons programme
without pre-wash. Set the temperature to the
level recommended on the drum cleaning
agent which can be found in the detergent aisle
in supermarkets . Apply this procedure without
any laundry in the product . Before starting
the programme, put 1 pouch of special drum
cleaning agent (if the special agent could not
be supplied, put max. 1 tea-cup of (max. 100
g) of antilimescale powder) into the main wash
detergent compartment. If the antilimescale
is in tablet form, put only one tablet into the
main wash compartment no. "2". Dry the
inside of the bellow with a clean piece of cloth
after the programme has come to an end.
C
INFORMATION
• Repeat Drum Cleaning process
in every 2 months.
• Use an anti-limescale suitable
for the washing machines.
After every washing and drying make sure
that no foreign substance is left in the drum.
If the holes on the bellow shown in the figure
are blocked, open the holes using a toothpick.
C
INFORMATION
• Foreign metal substances will cause
rust stains in the drum. Clean the
stains on the drum surface by using
cleaning agents for stainless steel.
Never use steel wool or wire wool.
A
CAUTION!
• Never use sponge or scrub materials.
These will damage the painted,
chrome and plastic surfaces.
6.3 Cleaning the body
and control panel
Wipe the body of the machine with soapy
water or non-corrosive mild gel detergents
as necessary, and dry with a soft cloth.
Use only a soft and damp cloth
to clean the control panel.
6.4 Cleaning the water
intake filters
There is a filter at the end of each water
intake valve at the rear of the machine and
also at the end of each water intake hose
where they are connected to the tap. These
filters prevent foreign substances and dirt
in the water to enter the washing machine.
Filters should be cleaned if they are dirty.
1. Close the taps.
2. Remove the nuts of the water intake
hoses to access the filters on the water
intake valves. Clean residues on them
with an appropriate brush. If the filters are
too dirty, remove them from their places
with a pliers and clean in this way.
3. Take out the filters on the flat ends of the
water intake hoses together with the gaskets
and clean thoroughly under running water.
4. Replace the gaskets and filters
carefully in their places and tighten
the hose nuts by hand.