HPP-432
Instruction for use
Page 1: ...HPP 432 Instruction for use ...
Page 2: ...e BEKO linear amplifier series Your BEKO linear amplifier will provide the proper sequencing of your preamplifier if connected as outlined later Preamplifiers such as the HPP 432 fall in the category of unprotected preamps meaning they are not RF sensed preamplifiers This means that if you transmit into the preamplifier without switching it out of line first you will damage the preamplifier Some r...
Page 3: ... two ways to power your preamplifier 1 Via the coaxial cable 2 Via a separate shielded cable connected to the SO239 jack Wire 13 8 VDC to the center pin wire ground to the connector shell HLV 550 770 1100 and 1470 Instructions These HLVs can provide the necessary voltage to power the HPP 432 via the coax cable In order to do so you must wire PIN 4 to Pin 2 located in the DIN control plug To avoid ...
Page 4: ...imode transceivers do not in most cases apply to the use of the BEKO HPP 432 ultra low noise preamplifier when used with an external transverter The following procedure is followed The HF radio s PTT can be used to key the BEKO linear amplifier Use the AUX out phono jack to key the transverter ...
