EN
Installation and operating manual
DRYPOINT
®
AC 410 – 495 | DRYPOINT
®
AC 410 – 495 MS
13
1.5. Intended use
DANGER
Improper use
Improper use can result in serious injury and damage to property.
• Only use the plant for its intended purpose.
DANGER
Operation of plant outside limit range
If the specified limits are exceeded, there is a risk of plant malfunction, potentially resulting in
injury and/or damage to property.
• The plant must only be operated for the intended use and within the permissible limits
specified on the type plate and in the technical data.
The plant must only be used for the intended purpose. The adsorption dryer has been specifically designed for the
drying of compressed air or nitrogen and must not be used for any other purpose.
The manufacturer shall not be liable for damage cause by improper use of the plant.
The medium to be dried must not contain any corrosive substances that might cause damage to the materials in
the adsorption dryer. To prevent unavoidable corrosion on carbon steel components during proper plant operation,
a 1 mm corrosion allowance or suitable coating has been applied.
The manufacturer guarantees that only materials suitable for the purpose have been used for the production of the
plant. If the plant operator requests the use of certain materials for specific plant components, it is the operator's
responsibility to ensure that these materials are suitable for the intended use.
The pressure and the temperature of the medium must conform to the specifications on the type plate and in this
installation and operating manual!
The plant is not designed to withstand loads from traffic, wind or earthquakes. In the event of such a load, take
suitable measures to protect the plant against the impact.
The manufacturer shall not be liable for damage and/or injury caused by non-compliance with the instructions
above or the general applicable safety rules and regulations. The manufacturer's liability shall also not apply, if the
adsorption dryer is operated without the necessary care or if best practice is not followed.
In order to ensure safe and trouble-free operation of the plant, always observe the safety instructions and other
information in this document.
Remember that the safety warnings and instructions always also refer to your personal safety!
For the operation of the adsorption dryer, strictly adhere to the relevant occupational safety and accident prevention
regulations and the instructions in this installation and operating manual. The adsorption dryer has been designed
and built according to best practice.
It conforms to the European Low Voltage Directive 73/23/EEC.
The design/development, production, assembly of this plant as well as all customer services are subject to the
certified quality assurance system of the manufacturer according to DIN ISO 9001/EN 29001.