Beko DIN15211, User Manual

Page: 12 / 43

10
Dishwasher / User’s Manual
/41 EN
Installation
Connection to the drain
Water discharge hose can directly be
connected to the drain hole or sink’s
drainage. The length of this connection
must be min. 50 cm and max. 100 cm from
the floor. A discharge hose longer than 4
meters will cause washing performance
to be affected.Attach the water discharge
hose to the drainpipe without bending
it. Tightly fix the water discharge hose
to the drainpipe in order to prevent any
dislocation of the water discharge hose
during operation of the product.
min 300
min 120
max 1000
min 500
Electrical connection
Before you insert the plug into the wall
socket make sure that the voltage and
the frequency shown in the rating label
corresponds to your electricity supply.
We recommend that this appliance be
connected to the mains supply via a
suitable switched and fused socket in a
readily accessible position.
If the supply cord or the mains lead is
damaged please do not replace it yourself.
The supply cord or the mains lead must be
replaced by a Authorised Service Agent or a
similarly qualified person.
A
This appliance must
be earthed
If the fitted moulded plug is not
suitable for your socket, then
the plug should be cut off and
an appropriate plug fitted.
Destroy the old plug, which is
cut off as a plug with a bared
cord could cause a shock
hazard if inserted into a socket
elsewhere in the house.
The moulded plug on this
appliance incorporates a 13A
fuse. Should the fuse need to
be replaced an ASTA approved
BS1362 fuse of the same rating
must be used. Do not forget
to refit the fuse cover. In the
event of losing the fuse cover,
the plug must not be used
until a replacement fuse cover
has been fitted. Colour of the
replacement fuse cover must
be the same colour as that
visible on the pin face of the
plug. Fuse covers are available
from any good electrical store.
C
Drainpipe must be connected
to the foul water system and it
should not be connected to any
surface water drain.
Adjusting the feet
If the door of the product cannot be closed
properly or if the product wobbles when
you push it slightly, then you need to adjust
the feet of the product. Adjust the feet of
the product as illustrated in the relevant
section.