EN
Installation and operating manual
BEKOMAT
®
3/6 CO Ex, 3/6 E Ex
7
1.4. Transport and storage
Despite our best efforts regarding packaging, etc., the device is susceptible to damage during transport. Upon
receipt, please remove all packaging material and inspect the device for visible damage. If you detect any such
damage, immediately notify the carrier company and BEKO TECHNOLOGIES GMBH or one of its agents.
CAUTION
Damage caused during transport or storage
Incorrect transport or storage, or the use of unsuitable lifting equipment might cause damage
to the device.
• The unit must only be transported and stored by authorised and suitably trained technical
personnel.
• If you detect any damage, do not start the device.
•
Always adhere to the specified transport and storage temperatures.
• Protect the unit against direct sunlight and heat radiation.
The device must be stored in the original
packaging. Seal the packaging and store it
in a dry and frost-free room. Ensure that the
storage temperature does not exceed the
limits specified on the type plate.
Even when packaged, take suitable
measures to protect the device against the
elements.
While in storage, secure the device so that
it cannot topple over or fall, and protect it
against vibration.
NOTE
Recycling of packaging material
• The packaging material is recyclable. Dispose of the packaging material according to the
applicable statutory regulations.
