EN
Installation and operating manual
BEKOMAT
®
3/6 CO Ex, 3/6 E Ex
23
7. Maintenance and servicing
DANGER
Insufficient qualification
Improper handling and operation of the unit can result in serious or even fatal injury, and/or
damage to property.
• All maintenance tasks must be performed by service personnel of BEKO
TECHNOLOGIES GMBH or an authorised BEKO partner.
7.1. Maintenance schedule
Maintenance
Interval
Function test
• Press the TEST button
• Visual inspection
daily
Maintenance
• Replace wearing parts (kit)
• Perform leakage test
• Perform function test
• Check adhesive label and replace, if necessary
• Check valve core length
• Check cable connections
• Test NAMUR interface
• Cleaning device
annually
Function test:
We strongly recommend performing a daily function test of the BEKOMAT
®
.
•
To test the solenoid valve, press the TEST button briefly (approx. 2 seconds).
→ The BEKOMAT
®
starts a manual drainage cycle.
• To test the NAMUR interface, close the condensate inlet and then press and hold the TEST button for 1 minute.
→ The BEKOMAT
®
starts a manual drainage cycle and triggers an alarm signal.
During this test, large volumes of compressed gas might enter the condensate collection line.
Maintenance:
For more information regarding the maintenance of the device, contact the manufacturer.
7.2. Cleaning device
To clean the BEKOMAT
®
, use a damp (but not wet) cotton cloth or disposable tissue and a mild conventional
detergent.
Spray a little detergent onto the clean cotton cloth or tissue and carefully wipe the component. Dry it with a clean
cloth. Observe all hygiene instructions applicable on the site.
NOTE
Damage caused by improper cleaning
Cleaning with a wet cloth, pointed implement or aggressive detergent can cause damage to
the device components and integrated electronic components.
• Never clean the device with a wet cloth.
• Do not use aggressive detergents.
• Do not clean the device with hard or pointed implements.
