Beko B7S-B7SLED, Service Handbook, Page: 40 / 100

B7S B7SLED WASHING MACHINE SERVICE HAND BOOK
40
Make sure that there is not any foreign bodies left inside the drum after each wash.
Figure 7.2 Cleaning the bellows
If the holes in the bellows shown in the Figure are clogged, open the holes by means of a
toothpick.
Rust stains may form inside the drum due to the metal objects. Clean the stains on
the surface of the boiler with stainless steel cleaning agents. Never use steel wool
or wire wool.
WARNING: Never use sponge or scrub materials. These will damage the painted
and plastic surfaces.
7.3. Cleaning the body and control panel
Wipe the body of the machine with soapy water or non-corrosive mild gel detergents as
necessary, and dry with a soft cloth.
Use only a soft and damp cloth to clean the control panel.
7.4. Cleaning the water inlet filters
There is a filter at the end of each water intake valve at the rear of the machine and also at
the end of each water intake hose where they are connected to the tap. These filters prevent
the foreign substances and dirt in the supply water to enter into the machine. Filters should
be cleaned when they become dirty.
Figure 7.3
1. Shut the taps.
2. Remove the nuts of the water inlet hoses and clean the sediments on the filters of the
water inlet valves with an appropriate brush. If the filters are too dirty, remove them from
their places with a pliers and clean in this way.
3. Remove the filters on the flat end of the water inlet hoses along with their seals and wash
them under running water well.
4. Replace the seals and filters carefully and tighten their nuts by hand.